The two things software cannot check by reading its own source are the 3 bit
packing and the bracket strategy, so both got a tool and a test.
New in the library (r8forge/tape.hh, src/tape.cc): the opcode numbering (taken
from ROT-8-viz enum, so the packed image and the hardware decoder cannot drift),
text <-> opcodes, opcodes <-> 3 bit bytes, the .r8t image with its trailer and
crc32, and a machine model that runs a packed tape the way a board would. The
model takes the bracket strategy as an option: backward scan with loop stack or
not, and jump-back-onto-the-[ (the contract) or past it (what the interpreters
do). All four combinations print the same thing, and the step count differs by
exactly the number of taken ] instructions -- which is what the test asserts.
Found and fixed while writing it: the loop stack discipline depends on the jump
convention. Jumping onto the [ means the [ re-pushes, so ] must pop on the jump;
jumping past it means the entry must stay until the loop exits. Mixing them up
emptied the stack on the second iteration of the calculator main loop -- caught
by the equivalence test on examples/calc.r8asm, not by reading the code.
Tools: r8forge_tape_pack (text tape -> image + --hex for $readmemh + --verify,
727 instructions become 273 bytes for hello, 62%, and the trailer sits past the
halt so address 0 of a ROM is instruction 0), and r8forge_tape_run now reads an
image directly and takes --loop-stack / --retest.
hardware/rot8.v: the 8 bit / 64 cell machine -- 3 bit opcodes from a byte
addressed memory read as a 16 bit window, a 6 bit dp with free wrap, the loop
stack bracket jump, blocking input, halt on ip == length, and a step counter that
counts instructions rather than cycles. hardware/tb_rot8.v loads a --hex image
and prints the OUT stream in tape_run format.
Verified with Icarus Verilog 14 (the RTL against tape_run --loop-stack --retest):
hello 577 instructions 417 steps 10 outs
term 16414 17643 11 (fed "lhi")
calc 51378 166741 19 (fed "12 34 + .": prints the prompt,
046 and the next prompt)
flagship 43676 100142 93
Every OUT stream identical. ctest -R rtl_sim runs that comparison from an 8 bit
build (11 tests in the default build now, where the RTL test self-skips because
the RTL is the 8 bit machine).
Two traps worth remembering: Icarus passes plusargs through as raw bytes, so an
absolute +HEX path containing non-ASCII (this checkout is under a Chinese
directory name) arrives mangled, $readmemh silently leaves the memory empty and
the machine obediently runs LEN steps of opcode 0 printing nothing -- run vvp
from the directory holding the hex with a relative name. And in_ready must not
be qualified with !in_valid or the input handshake deadlocks.